Eriks
SKF

Taconite seal for Series TK

The Taconite Seal consists of two rings (one stationary and one rotating) which form a very narrow labyrinth between the two rings. The rotating labyrinth ring carries a V-ring seal that seals against the stationary labyrinth ring. The V-ring seal blocks contaminants from entering the bearing housing and aids the purging of contamination and old grease when something like a mining seal is re-greased.

Features
  • Cartridge Taconite Seal of machined cast iron or steel
  • Three and four axial labyrinth stages
  • Internal V-ring seal to exclude contaminants and enable grease to purge
  • Rotating labyrinth ring faces bearing housing to deflect and fling away water
  • Short installed axial length
  • The rotating labyrinth ring is sealed to the shaft by an O-ring in its bore
  • 3 grub/set screws (at 120°) to center the seal on the shaft
  • ± 0.5° misalignment capability
  • Circumferential groove to aid alignment and assembly
  • Fits SKF metric SE, SNL, SNL 30, 31 and 32 series
Image 1
Image 2
Image 1
Image 2
  • 1
  • 1
  • 1
  • 1
  • 1
  • 1
  • 1
  • 1
  • 1
  • 1
  • 2
  • 1
  • 1
  • 1
  • 1
  • 1
8 of Taconite seal for Series TK
ProductInner Diameter [mm]Outer Diameter [mm]Width [mm]AvailablePriceexcl. VAT